Preview — Single Bar
Bar Dimensions
mm
mm
mm
Slot Dimensions
mm
mm
mm
mm
mm
Slot 1 at X31mm · Slot 2 at X162mm from bar left end
Cutter & Depth
mm
mm
mm/min
mm/min
Pass 1 (roughing)Z−4.5mm
Pass 2 (full depth)Z−9.0mm
Cutter radiusr = 3.0mm
Outer Profile Bridges
mm
Bridge depth: Z−4.5mm (half depth — 4.5mm of material holds bar)
Snap bar free after machining — clean snap-off point with a chisel.
Nesting
bars
mm
mm
mm
Geometry Notes
• Cutter r = 3.0mm · Outer profile outset by 3.0mm
• Slot straight section: 4.0mm (10−6mm)
• Slot 1 at X31mm · Slot 2 at X162mm from bar left
• Bar centre Y: 12.5mm · Slot at Y12.5mm
• NCStudio V5.4.48 format — no spaces inside instruction blocks ✓
• Two depth passes — slots cut FIRST, then outer profile